Ring gag head harness with medium leather wrapped ring. The head harness is crafted in my heavy bondage leather. The piece starts with the gag. To the gag is attached welded rings. From these rings the harness is built. Heading north is the two thin pieces of leather that run up the face, meeting at a welded d-ring and continuing back down the middle of the head as a single 1” strap. Running east and west of the rings are 1” straps, each holding a 1” heavy duty roller buckle. Heading south is the 3/4” chin strap closing with a smaller roller buckle. The piece closes in the back with 1” strapping. The gag is crafted using a steel ring. The ring is then wrapped with a soft garment leather and then attached to the welded rings via a soft garment leather. These rings attach to the harness. The ring size is measured before the leather wrap is applied. The leather will add to the size a trifle. This ring is 1 & 15/16" outside diameter, the inside diameter is unimportant cause if the outside is too big, this is impossible to wear. The jaw can only open so far.

Your Name:
*Email Address:
Review:
Your Rating:	1 out of 5 2 out of 5 3 out of 5 4 out of 5 5 out of 5
Verification:	(Reload Image)
	*Your email address will not be shared with anyone.