This ball gag head harness is crafted in my heavy bondage leather. The piece starts with the gag. To the gag is attached welded rings. From these rings the harness is built. Heading north is the two thin pieces of leather that run up the face, meeting at a welded d-ring and continuing back down the middle of the head as a single 1” strap. Running east and west of the rings are 1” straps, each holding a 1” heavy duty roller buckle. Heading south is the 3/4” chin strap closing with a smaller roller buckle. The piece closes in the back with 1” strapping. The gag is a black hard rubber ball with a hole drilled through it. Through that hole is a soft garment leather holding the ball to the rings. The rings are then attached to the leather head harness. Voila! Ball gag head harness.

Your Name:
*Email Address:
Review:
Your Rating:	1 out of 5 2 out of 5 3 out of 5 4 out of 5 5 out of 5
Verification:	(Reload Image)
	*Your email address will not be shared with anyone.